nrgracing

/2 fast

About 2 fast

This author has not yet filled in any details.
So far has created 56 blog entries.
511, 2018

Thive Drag races with multiple records!

By |November 5th, 2018|News|Comments Off on Thive Drag races with multiple records!

We attend in Kopaida dragster raceway with the support of many racing teams. We saw 2 world records with 0-400tune2race making one of those with 7.54sec at 1/4 mile and his R32 engine. Glad to see you all there and hope the best for every race.

Thanks all teams and tuners below:

Mamos, Markesinis, 0-400tune2race, Koutras, Dynodrome, Georgiadis, Vouros, SVS, Liaskos, Daflos and Demos.

2610, 2018

FAT Angle Kits now available!

By |October 26th, 2018|Offer|Comments Off on FAT Angle Kits now available!

Front Angle kits, made to order with delivery time 20-30 days from FAT, prices incl. TAX:

BMW E36 1.180

Nissan 200SX 1.260

Mazda RX-8 1.645

Nissan 350z 1.845

2510, 2018

Energie Racing in MDC Marathon 20-21 Octomber

By |October 25th, 2018|News|Comments Off on Energie Racing in MDC Marathon 20-21 Octomber

Thanks PB motorsport winning 1st place in Street Legal series with their Toyota Corolla 1.6turbo

and Liberis team in Pro Series with Nissan Silvia 2JZ swap.

510, 2018

Mazda RX8 Aeroflow Ignition Kit – 400 euro

By |October 5th, 2018|Offer|Comments Off on Mazda RX8 Aeroflow Ignition Kit – 400 euro

RX-8 kitThe RX-8 upgrade ignition kit refers to all RX-8 models. This kit will replace the existing ignition coils with Capacitive Discharge Multiple Spark Coils.

The RX-8 upgrade ignition kit refers to all RX-8 models. This kit will replace the existing ignition coils with Capacitive Discharge Multiple Spark Coils. To optimize the performance all parts have been carefully selected by our team. Curved heat resistant boots, thick spark plug wire, high power ignition coils and durable harness are the parts. The kit is accompanied with special harness for the coil connection. This way you will not cut any wire from the factory harness. The kit will give to your engine smoother start more power and less misfires.

Installation Steps
Remove the old ignition coils.
Choose the place that you will install the coils and install them (the mounting kit for the coils is not included).
Connect the coil connector harness to the old connectors and the coils.
Measure the length of each spark plug wire and cut the cable.
Install the boots on the wires.
Plug in the spark plug wires to the coil.
Note:Some of these steps have to be done by an expert.

Coil Tech Specs
Turns ratio 52:1
Primary resistance . 57 OHMs
Secondary resistance 3.1K OHMs
Inductance 5.8 mH
Maximum voltage 44,000 Volts
Peak current 150 mA
Spark duration 1200 uS
Weight 1000g
Dwell Time 4.5ms Current Draw: 8A

510, 2018

NRG Racing attends in Kings of Europe Pro Series

By |October 5th, 2018|News|Comments Off on NRG Racing attends in Kings of Europe Pro Series

We attend with Hercules Leontis in Greinbach, Austria at 29/30 Octomber with good results as Leontis qualified in best 25 drivers for the event.

Now we will be with Leontis again in Serres for the event here in Greece at 6/7 September. Our best wishes for Hercules and his Nissan 200sx swapped lexus engine.

Very good work from his tuner and engineer who support him in every race.

1108, 2018

Dragy now in stock!

By |August 11th, 2018|Offer|Comments Off on Dragy now in stock!

Dragy GPS performance meter pairs with your IOS or Android device to give accurate rates of acceleration and distance measurements. Metric and imperial are supported. Results are validated for incline and results can be posted optionally on our leaderboard.

Video in Motion

Film your runs with in video increments (Android support under development)

Retail: 160 euro incl. TAX, get 10% discount until end of September.

specs

2407, 2018

E85 265 LPH Hi-Flow In-Tank Pump 70 GPH (265 LPH) @ 40 Psi Suit Audi & VW

By |July 24th, 2018|Offer|Comments Off on E85 265 LPH Hi-Flow In-Tank Pump 70 GPH (265 LPH) @ 40 Psi Suit Audi & VW

Introducing the new Aeroflow Performance 265 LPH Hi-flow in-tank efi fuel pump. For such a compact and small design this fuel pump is capable of flowing 70 GPH (265 LPH) @ 40 Psi. With such a small and compact design it will fit in O.E.M modern European fuel tanks such as the Audi and VW that are all-wheel-drive configurations.

The external design on the outlet end cap which is compact and a 90 degree angle barb allows this pump to fit into the all-wheel-drive tanks. No wiring is needed when fitting this pump as the connector matches factory wiring in Audi and VW.

It is compatible with all fuels such as pump fuel and E85. Horsepower capabilities? This fuel pump can support over 500hp on pump fuel with just one single fuel pump.

Retail price: 180 euro incl. Tax

2007, 2018

Energie Racing Parts in Malta National Drag Races

By |July 20th, 2018|News|Comments Off on Energie Racing Parts in Malta National Drag Races

Energie Racing Parts now in Malta national drag races.

Good luck to all Greek racing teams and thanks for their support.

2405, 2018

Group V.A.G. 2.0T FSI / TSI Engine or DSG oil cooler kit -10%

By |May 24th, 2018|Offer|Comments Off on Group V.A.G. 2.0T FSI / TSI Engine or DSG oil cooler kit -10%

In offer from 1st to end of June, DSG or Engine oil cooler kit with Aeroflow 16 or 19 rows cooler in black or silver colour, aeroflow SS or Naylon braided 10AN lines, aeroflow fitting and 10AN hose ends with multiple options in colours and last NRG CNC adapter.

MSRP price DSG kit: 380 euro incl. TAX (345 now)

MSRP price Engine kit: 350 euro inc. TAX (315 now)

2405, 2018

Energie Racing CNC Handbrake with Wilwood master cylinder!

By |May 24th, 2018|News|Comments Off on Energie Racing CNC Handbrake with Wilwood master cylinder!

Energie introduce the new 40cm tall hydraulic CNC handbrake with adjustable lever position up to 30 degrees in 1 second.

Of course there is the classic adjusting option with 45 and 90 degrees with a bolt on the main body.

We suggest getting Wilwood master cylinder for better response and reliability.

MSRP price 210 incl. TAX